User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Wireless Security Settings 3-9
v1.0, June 2008
Configuring WPA with RADIUS
Not all wireless adapters support WPA. Furthermore, client software is required on the client.
Vista, Windows XP and Windows 2000 with Service Pack 3 or later do include the client software
that supports WPA. Nevertheless, the wireless adapter hardware and driver must also support
WPA. Consult the product document for your wireless adapter and WPA client software for
instructions on configuring WPA settings.
To configure WPA, follow these steps:
1. Under the Configuration tab, select Security on the main menu, select Advanced from the
side menu, and then select RADIUS Server Settings. The RADIUS Server Settings screen
displays.
2. Enter the RADIUS server settings as shown in “Configuring the RADIUS Server Settings” on
page 4-13.
3. Click Apply to save your RADIUS server settings.
4. Under the Configuration tab, select Security from the main menu, and then select Security
Settings from the side menu.
Figure 3-4 WPA with RADIUS security settings
5. Select WPA with RADIUS from the Network Authentication drop-down menu. Data
encryption will be set to TKIP by default (see
Figure 3-4).