User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Installation and Configuration 2-15
v1.0, June 2008
Logging in to the NETGEAR Wireless-N Access Point
The WN802Tv2 is set, by default, with the IP address of 192.168.0.233 with DHCP disabled.
Note: If logging in using the default IP address, the computer you are using to connect to
the WN802Tv2 should be configured with an IP address that starts with
192.168.0.x and a subnet mask of 255.255.255.0.
If DHCP is enabled, you can connect to the WN802Tv2 after the DHCP server on your network
assigns it a new IP address:
Figure 2-8 Enable DHCP client
Reserve an IP address (based on the WN802Tv2’s MAC address) on the DHCP server. That
way, if your router is deployed across several segments, you can configure the wireless access
point with a static IP address which you can always use to log in to make future configuration
changes.
To log in using the default IP address:
1. Open a Web browser such as Mozilla Firefox or Internet Explorer.