User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Installation and Configuration 2-13
v1.0, June 2008
2. Connect an Ethernet cable from your NETGEAR Wireless-N Access Point to a LAN port on
your router, switch, or hub. Connect the power adapter to the wireless access point and plug
the power adapter into a power outlet. The PWR, LAN, and Wireless LAN LEDs and should
light up
Tip: Before mounting the WN802Tv2 in a high location, first set up and test the
WN802Tv2 to verify wireless network connectivity.
Install the Wall Mount Kit (Optional)
Before you begin installation, check to make sure that the four screws selected to secure the
brackets fit flush within the molding of the bracket. An illustration of the installation steps is
shown in
Figure 2-7.
To install the wireless access point mounting brackets:
1. Place the bottom bracket on the wall where you want to install the WN802Tv2. Securely screw
the bottom bracket into the wall, making sure the screws are flush with the bracket (Step 1).
2. Snap the WN802Tv2 into place on the bottom bracket (Step 2). The tabs on the bottom of the
bracket will snap into the slots on the bottom of the WN802Tv2.
3. Firmly secure the top bracket onto the WN802Tv2 and attach the bracket with two additional
screws (Step 3). Ensure that the bracket flange engages with the top lip of the WN802Tv2
before screwing in the bracket.
Should you need to remove the WN802Tv2, unscrew the top bracket, and then unsnap the
WN802Tv2 from the bottom bracket. Never try to remove your wireless access point before
removing the top bracket.