User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Installation and Configuration 2-11
v1.0, June 2008
The default setting is Enabled.
To configure your wireless QoS settings for 11b, 11bg, or 11ng modes:
1. Under the Configuration tab on the main menu, select Wireless, then select QoS Settings
under Basic from the side menu. The QoS Settings screen displays, as shown in
Figure 2-6:
Figure 2-6 QoS settings
2. Wi-Fi Multimedia (WMM) is enabled by default. Check the Disable checkbox to disable
WMM support.
3. Click Apply to save your settings.
Configuring WMM Power Save
WMM power save is a set of features in 802.11e that help to conserve power for battery-operated
devices in a wireless LAN.
To configure WMM Power Save settings:
1. Under the Configuration tab on the main menu, select Wireless, then select QoS Settings
under Basic from the side menu. The QoS settings screen displays (see
Figure 2-6).
2. WMM Power Save is enabled by default. Check the Disable checkbox to disable it.
3. Click Apply to save your settings.