User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
2-6 Installation and Configuration
v1.0, June 2008
3. .Click Apply to save your settings.
Note: If you do not have an Internet connection to get the current time, the wireless
access point will get the current time from the connecting PC.
To configure the Basic LAN settings:
1. Select IP under Configuration on the main menu. The IP Settings screen displays (see
Figure 2-4).The default settings should be suitable for most users and environments.
Figure 2-4 Basic IP settings
2. Enter the IP Settings fields of the WN802Tv2.
– DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is
disabled. If you have a DHCP server on your LAN you can enable DHCP and the wireless
access point will get its IP address, gateway and DNS server settings automatically when
you connect the WN802Tv2 to your LAN.
– IP Address. Enter the IP Address of your wireless access point. The default IP address is
192.168.0.233. To change it, enter an unused IP address from the address range used on
your LAN; or enable DHCP.
– IP Subnet Mask. Enter the subnet mask based on the IP address that you assign. The
default is 255.255.255.0.