User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Installation and Configuration 2-5
v1.0, June 2008
To select the local time zone:
1. Select Configuration > System > Basic > Time. The Time Settings screen displays.
Figure 2-3 Local time zone settings
2. Configure the following information:
– Time Zone. From the pull-down menu, select the local time zone for your wireless access
point from a list of all available time zones. The default is USA-Pacific.
– Check the Daylight Saving checkbox if your location uses daylight saving. The default is
no adjustment.
– NTP Client. Enable NTP Client to synchronize the time of the access point with an NTP
Server. The default is Enabled.
Note: You must have an Internet connection to get the current time.
– Use Custom NTP Server. Check the option if you have a custom NTP server. The default
is Disabled.
– Hostname/IP Address. Enter the host name or the IP address of the custom NTP server.
The default is time-b.netgear.com