User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
1-2 Introduction
v1.0, June 2008
• Multi-In, Multi-Out (MIMO) technology. Provides improved communication performance
without additional bandwidth or transmit power. .
• Standards Compliance. Complies with Draft 2.0 802.11n for wireless LANs, and is
backward compatible with 802.11bg.
• Full WPA and WPA2 support. WPA and WPA2 personal and enterprise-class strong security
with dynamic encryption key generation. TKIP and AES encryption are supported.
• RADIUS authentication support.
• DHCP client support. The WN802Tv2 can act as a DHCP client and obtain information from
your DHCP server for the WLAN.
• Access control MAC address filtering. The access control MAC address filtering feature can
ensure that only trusted wireless stations can use the WN802Tv2 to gain access to your LAN.
Local and remote MAC address authentication are supported.
• Easy-to-use web-based GUI. A web-based GUI makes installation and management easy for
all users.
• Auto-sensing ethernet connection with Auto-Uplink interface. Connects to 10/100/1000
Mbps IEEE 802.3 Ethernet networks.
• WMM Power Save. Allows power-critical devices to fine-tune power consumption and save
power by buffering data transmitted to them.
• Front panel LEDs. Front panel LEDs allow easy monitoring of status and activity.
• Flash memory. Allows for easy firmware upgrades.
• Quality of Service (QoS) Support. You can configure parameters that affect traffic flowing
from the wireless access point to the client station and from the client station to the wireless
access point. The QoS feature allows you to prioritize time-sensitive traffic such as voice and
video traffic.
• Three modes for maximum flexibility:
– Access Point. In this mode, operates as a standard 802.11n wireless access point.
– Wireless Multi-Point Bridging. In this mode, acts as a wireless AP or wireless bridge.for
a group of bridge-mode wireless partners.
– Wireless Repeater Bridging. In this mode, operates as both a wireless access point and a
wireless bridge without client association.