User Manual
Table Of Contents
- Contents
- About This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Chapter 3 Wireless Network Performance
- Chapter 4 Troubleshooting
- Appendix A Default Configuration Settings and Technical Specifications
- Appendix B Related Documents
NETGEAR RangeMax Wireless-N ExpressCard WN711 User Manual
2-18
v1.0, June 2008
b. In the Network Name (SSID) field, select the network, or enter the SSID.
c. In the Security section of the screen, select WPA2-PSK [AES], and enter the passphrase.
The passphrase can be a word or group of printable characters. For more information
about wireless security, see the link to the online document “Wireless Networking Basics”
in Appendix B.
3. Save your settings in a profile.
a. Click Save Profile. All the configuration settings are saved in this profile.
b. Click Apply, and then click Close to exit the Smart Wizard.
Setting Up WPA-PSK Security
To configure WPA-PSK security:
1. Run the Smart Wizard.
a. Make sure that the NETGEAR software is installed and the Wireless Express Card is fully
inserted in the Express Card slot in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab displays.
2. Configure the security settings.
Note: You will not get a wireless network connection unless the SSID that you
enter exactly matches the SSID used by the access point.
Figure 2-17