User Manual
Table Of Contents
- Contents
- About This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Chapter 3 Wireless Network Performance
- Chapter 4 Troubleshooting
- Appendix A Default Configuration Settings and Technical Specifications
- Appendix B Related Documents
NETGEAR RangeMax Wireless-N ExpressCard WN711 User Manual
2-12
v1.0, June 2008
To create an Ad Hoc mode profile:
1. Use the icon to open the Smart Wizard. The Settings tab displays.
2. Enter the network settings.
a. Select Computer-to-Computer (Ad Hoc) for the network type.
b. Select or enter the network vame (SSID) for the Ad Hoc network.
c. In the Profile field, type the name of the profile.
d. Click Apply.
3. Save your settings in a Profile.
a. Click the Save Profile button.
The configuration settings are saved in this profile.
b. Click Apply, and then click Close to exit the Smart Wizard, or Cancel to return to the
previous settings.
4. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
b. Restart the PCs.
Figure 2-11
Note: For instructions on configuring static IP addresses, see the link to the online
document “TCP/IP Networking Basics” on page B-1.