User Manual
Table Of Contents
- Contents
- About This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Chapter 3 Wireless Network Performance
- Chapter 4 Troubleshooting
- Appendix A Default Configuration Settings and Technical Specifications
- Appendix B Related Documents
NETGEAR RangeMax Wireless-N ExpressCard WN711 User Manual
1-3
v1.0, June 2008
Your Wireless Express Card factory default basic settings are:
• Network Name Service Set Identifier (SSID): Any
• Network Mode (Infrastructure or Ad Hoc): Infrastructure
• Data security WEP, WPA2-PSK, or WPA-PSK encryption: Disabled
Installation
The instructions in this section explain how to install the Wireless Express Card to connect to a
network with an access point or router. Wireless security, advanced settings, and Computer-to-
Computer (Ad Hoc) instructions are covered in Chapter 2, “Network Connections and Wireless
Security”.
To install the Wireless Express Card:
1. First, install the WN711 software.
Insert the Resource CD. If the CD main screen does not display, double-click Autorun.exe on
the CD.
a. Click Install the Software. The Check for Updates screen displays.
Note: In order for the Wireless Express Card to communicate with a wireless access
point or wireless adapter, all devices must be set up to use the same wireless
network name (SSID).
Figure 1-1