User's Manual
Table Of Contents
- NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
- Contents
- About This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Disabling the Windows Zero Configuration Utility
- Understanding the Smart Wizard
- Viewing Wireless Networks in Your Area
- Finding a Network
- Profiles
- Setting Up a Profile to Connect to an Access Point or Router
- Setting up a Computer-to-Computer (Ad Hoc) Profile
- Wireless Security
- Using Wireless Security Features
- Wireless Network Name (SSID) and Security Settings
- Setting Up WPA-PSK Security
- Setting Up WEP Encryption Security
- Statistics Tab
- About Tab
- Advanced Settings
- Chapter 3 Wireless Network Performance
- Chapter 4 Troubleshooting
- Appendix A Technical Specifications and Factory Default Settings
- Appendix B Related Documents
NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
2-8
v1.0, December 2007
2. Enter the network settings.
a. Select Computer-to-Computer (Ad Hoc) for the network type.
b. Select or enter the network name (SSID) for the Ad Hoc network.
c. In the Profile field, type the name of the profile.
d. Click Apply.
3. Save your settings in a profile.
a. Click Save Profile, and all the configuration settings are saved in this profile.
b. Click Apply, then click Close to exit the Smart Wizard, or click Cancel to return to the
previous settings.
4. Configure the computer network settings.
a. Configure each computer with either a static IP address or with the IPX protocol.
b. Restart the computers.
5. Verify wireless connectivity between your peer devices with the ping program:
a. On the Windows taskbar, select Start > Run.
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type:
ping -t 192.168.0.1
and then click OK.
Figure 2-6