User's Manual
Table Of Contents
- NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
- Contents
- About This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Disabling the Windows Zero Configuration Utility
- Understanding the Smart Wizard
- Viewing Wireless Networks in Your Area
- Finding a Network
- Profiles
- Setting Up a Profile to Connect to an Access Point or Router
- Setting up a Computer-to-Computer (Ad Hoc) Profile
- Wireless Security
- Using Wireless Security Features
- Wireless Network Name (SSID) and Security Settings
- Setting Up WPA-PSK Security
- Setting Up WEP Encryption Security
- Statistics Tab
- About Tab
- Advanced Settings
- Chapter 3 Wireless Network Performance
- Chapter 4 Troubleshooting
- Appendix A Technical Specifications and Factory Default Settings
- Appendix B Related Documents
NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
2-6
v1.0, December 2007
1. Use the icon to open the Smart Wizard. The Settings tab displays:
2. Enter the network settings.
a. In the Network Type section, make sure that Access Point (Infrastructure) is selected.
b. In the Profile field, type the name of the profile.
c. In the Network Name (SSID) field, select a network or enter the SSID.
3. Save your settings in a Profile.
a. Click Save Profile.
All the configuration settings are saved in this profile.
b. Click Apply, then click Close to exit, or click Cancel to return to the previous settings.
4. Verify wireless connectivity to your network.
Figure 2-4
Note: You will not get a wireless network connection unless the network SSID
matches exactly the SSID used by the access point.