User's Manual
Table Of Contents
- NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
- Contents
- About This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Disabling the Windows Zero Configuration Utility
- Understanding the Smart Wizard
- Viewing Wireless Networks in Your Area
- Finding a Network
- Profiles
- Setting Up a Profile to Connect to an Access Point or Router
- Setting up a Computer-to-Computer (Ad Hoc) Profile
- Wireless Security
- Using Wireless Security Features
- Wireless Network Name (SSID) and Security Settings
- Setting Up WPA-PSK Security
- Setting Up WEP Encryption Security
- Statistics Tab
- About Tab
- Advanced Settings
- Chapter 3 Wireless Network Performance
- Chapter 4 Troubleshooting
- Appendix A Technical Specifications and Factory Default Settings
- Appendix B Related Documents
NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
1-12
v1.0, December 2007
1. The wireless USB adapter comes with three black fasteners. Locate the one with a prickly
side, and attach it to the plastic cradle on the middle of the outside rear.
2. Insert the wireless USB adapter in the plastic cradle, and connect the USB cable.
4. Place one of the other pieces of loop-and-hook fastener on the side or back of your monitor
near the top for better reception. Then join the pieces of the fastener to attach the USB adapter
in the plastic cradle to the monitor.
Figure 1-10
Figure 1-11
Figure 1-12