User's Manual
Table Of Contents
- NETGEAR RangeMax Wireless-N USB 2.0 Adapter WN111 User Manual
- Contents
- About This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Disabling the Windows Zero Configuration Utility
- Understanding the Smart Wizard
- Viewing Wireless Networks in Your Area
- Joining a Network
- Profiles
- Setting up a Profile to Connect to an Access Point or Router
- Setting up a Computer-to-Computer (Ad Hoc) Profile
- Wireless Security
- Using Wireless Security Features
- Wireless Network Name (SSID) and Security Settings
- Setting up WEP Encryption Security
- Setting up WPA-PSK Security
- Statistics Tab
- About Tab
- Advanced Settings
- Chapter 3 Wireless Network Performance
- Chapter 4 Troubleshooting
- Appendix A Technical Specifications and Factory Default Settings
- Appendix B Related Documents
NETGEAR RangeMax Wireless-N USB 2.0 Adapter WN111 User Manual
2-12
v1.0, July 2007
Setting up WEP Encryption Security
Follow the steps below to configure WEP Encryption Security.
1. Run the WN111 Smart Wizard.
a. Make sure the WN111 software is installed and the WN111 is connected to the USB port
in your computer.
b. Use the icon to open the Smart Wizard. The Settings screen displays.
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
c. In the Security section, select WEP.
Figure 2-9
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.