User's Manual
Table Of Contents
- NETGEAR RangeMax Wireless-N USB 2.0 Adapter WN111 User Manual
- Contents
- About This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Disabling the Windows Zero Configuration Utility
- Understanding the Smart Wizard
- Viewing Wireless Networks in Your Area
- Joining a Network
- Profiles
- Setting up a Profile to Connect to an Access Point or Router
- Setting up a Computer-to-Computer (Ad Hoc) Profile
- Wireless Security
- Using Wireless Security Features
- Wireless Network Name (SSID) and Security Settings
- Setting up WEP Encryption Security
- Setting up WPA-PSK Security
- Statistics Tab
- About Tab
- Advanced Settings
- Chapter 3 Wireless Network Performance
- Chapter 4 Troubleshooting
- Appendix A Technical Specifications and Factory Default Settings
- Appendix B Related Documents
NETGEAR RangeMax Wireless-N USB 2.0 Adapter WN111 User Manual
2-4
v1.0, July 2007
• MAC Address. Identifies the hardware address (MAC Address) of the wireless device
broadcasting this information.
• Mode. Identifies the type of wireless network — Access Point (Infrastructure) or Computer-
to-Computer (Ad Hoc)
Joining a Network
During the WN111 software installation, the Smart Wizard lists the available networks. After
installation you can use the Join a Network button on the Network tab at any time to view the
available networks and select the one that you want to use.
To join a network:
1. Use the icon to open the Smart Wizard. On the status bar, click Join a Network. The
following screen displays:
Note: Make sure that you know the security settings for the network that you want to use.
For example, if WEP is used then you need to know the WEP key. If you use
secure networks frequently, set up profiles for each network with the wireless
network and security settings.
Figure 2-3