User Manual
Table Of Contents
- About This Manual
- Conventions, Formats, and Scope
- How to Print This Manual
- Chapter 1 Basic Setup
- Chapter 2 Network Connections and Wireless Security
- Understanding the WN311B Smart Wizard
- Finding a Network
- Profiles
- Setting up a Profile to Connect to an Access Point or Router
- Setting up a Computer-to-Computer (Ad Hoc) Profile
- Wireless Security
- Using Wireless Security Features
- Wireless Network Name (SSID) and Security Settings
- Setting up WEP Encryption Security
- Setting up WPA2-PSK Security
- Setting up WPA-PSK Security
- Networks Page
- Statistics Page
- About Page
- Chapter 3 Troubleshooting
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
NETGEAR RangeMax™ NEXT Wireless PCI Adapter WN311B User Manual
2-6 Network Connections and Wireless Security
v1.0, May 2006
a. Click the Save Profile button.
All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.
4. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
b. Restart the PCs.
5. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
address. The ping response should change to “reply.”
Note: For instructions on configuring static IP addresses, refer to the networking
tutorial on your Resource CD.
a. On the Windows taskbar click the Start
button, and then click Run.
b. Assuming the target PC is configured
with 192.168.0.1 as its IP address, type
ping -t 192.168.0.1 and then click
OK.
Figure 2-4
Figure 2-5