User's Manual

Reference Manual for the NETGEAR ProSafe VPN Client
NETGEAR VPN Client to NETGEAR FVL328 or FWAG114 VPN Router D-5
202-10015-01
3.
Click the VPN Policies link under the VPN category on the left side of the main menu. This
will take you to the VPN Policies Menu page. Click Add Auto Policy. This will open a new
screen titled VPN – Auto Policy.
Figure D-4: NETGEAR FVL328 VPN – Auto Policy General settings
– Enter a unique name to identify this policy. This name is not supplied to the remote VPN
endpoint. In our example we have used to318 as the Policy Name. In the Policy Name
field type VPNclient.
– From the IKE policy drop-down box, select VPNclient which is the IKE Policy that was
set up in the earlier step.
– From the Remote VPN Endpoint Address Type drop-down box, select IP Address.
–Type 0.0.0.0 as the Address Data of the client because we are assuming the remote PC will
have a dynamically assigned IP address. This will also be entered in the NETGEAR
ProSafe VPN Client Internal Network IP Address field, as seen in “My Identity“ on page
D-10.
–Type 86400 in the SA Life Time (Seconds) field.
–Type 0 in the SA Life Time (Kbytes) field.
– Check the IPSec PFS checkbox to enable Perfect Forward Secrecy. This will also be
entered in the NETGEAR ProSafe VPN Client Security Policy Enable Perfect Forward
Secrecy checkbox, as seen in “Security Policy“ on page D-11.
– From the PFS Key Group drop-down box, select Group 2 (1024 Bit). This will also be
entered in the NETGEAR ProSafe VPN Client Security Policy PFS Key Group
drop-down selection box, as seen in “Security Policy“ on page D-11.