User manual

10 NS380 / NS380W User Guide
YML826 Rev1 - Pan/Tilt Internet Camera
Hardware Installation
Connecting the Ethernet cable
Connect an Ethernet cable to the network cable
connector located on the Pan/Tilt Internet Camera’s
rear panel, and then attach it to the network.
Attaching the Power Supply
Attach the external power supply to the DC power
input connector located on Pan/Tilt Internet Camera’s
rear panel, and then connect it to your local power
supply.
Attaching the Metal Mounting Plate
To attach the metal plate, remove the two rubber
pads under the base of the camera firstly. Place the
metal plate onto the camera base, and align the two
holes of metal plate with two screw holes on the
base. Secure the metal plate to the base with two
screws (provided). Then, you can:
1. Install the camera to the ceiling using
two ceiling screws (a); or,
2. Install the camera to the wall using two
wall screws (b).
TIP: You can confirm power source is supplied from the LED indicators
label Power on the Pan/Tilt Internet Camera is illuminated.
(a) (b)
Base of Camera