User guide
72
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
UM-00003
www.netcommwireless.com
Administration
The Administration page is used to enable or disable the firewall, remote administration, telnet access and ping responses.
Figure 75 - Administration Configuration Items
OPTION
DEFINITION
Firewall
Enable or disable the in-built firewall on the router.
Enable HTTP
Enable or disable remote HTTP access to the router. You can also set the port you would like remote HTTP access to be available on.
Enable Telnet
Enable or disable telnet (command line) access to the router.
Enable Ping
Enable or disable ping responses on the WWAN connection.
Web User Interface Account
Username
Select the username you would like to change the password for. Root users have write permissions for both the root and admin
accounts. Admin users can only update the admin password.
Password
Enter the new password for the selected user account.
Confirm Password
Re-enter the new password for the selected user account.
Telnet Account
User Name
The Telnet Account settings are only available when logged into the router as the ‘root’ user.
Password
Enter the new password for the root telnet user account.
Confirm Password
Re-enter the new password for the root telnet user account.
Table 35 - Administration Configuration Items
Note: The password will only be changed if you enter two matching passwords. It is not necessary to change the password
if you are only changing the incoming port number.
To access the router’s configuration pages remotely from a remote computer, perform the following steps:
1.
Open a new browser window (e.g. Internet Explorer, Firefox, Safari ...).
2.
In the address bar, enter the router’s WAN IP address and assigned port number, e.g. “10.10.10.10: 8080”.
Note: You can find the router’s WAN IP address by clicking on the “Status” menu. The Local field in the WWAN section
shows the router’s WAN IP address.
Click “Login” and type admin or root in the Username and admin in the Password fields. Then click on “Submit”.
Note: To perform functions like Firmware upgrade, device configuration backup and to restore and reset the router to factory
defaults, you need to login as the root user.