User guide

70
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
UM-00003
www.netcommwireless.com
Figure 71 - Recovery Console Banner
To upload the main system software, click on “Application Installer” from the menu at the top of the page and then click on the
browse button and navigate to where the main system image upgrade file is located on your computer.
Once you have selected the recovery image file to use, click Upload to upload the file. You will then see a progress bar as shown in
the screenshot below. The upload has finished when the status bar reaches 100%.
Figure 72 - Recovery Console - Upload Firmware
When the upload has completed, the screen should refresh and show the file you have just uploaded. Click on the “Install” link to
the right of this.
Once you see “Done” shown as per the screenshot below, click on “Reboot” at the top of the page and then click the Reboot
button to restart the router.
Figure 73 - Recovery Console - Firmware Update
The router will confirm you want to restart and then start up with the new system software loaded.