User guide

62
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
UM-00003
www.netcommwireless.com
Enable Authentication
Enable or disable checking the sender’s phone number against the allowed sender “White List” for incoming Diagnostics/Command
Execution SMS messages.
If authentication is enabled, the router will check if the sender’s number exists in the “White List”. If it exists, the router then checks
the password in the incoming message against the password in the “White List” for the corresponding sending number. If they
match, the Diagnostics/Command is executed.
If the number does not exist in “White List” or the password does not match, the router does not execute the incoming
Diagnostics/Command Execution SMS message.
This is enabled by default.
It is highly recommended to enable security when utilising the Diagnostics/Command Execution feature.
Send Ack. SMS for Set Command
Enable or disable sending an acknowledge message after execution of a “Set” command.
If disabled the router does not send any acknowledgement after execution of a “Set” command. This can be useful to determine if a
command was received and executed by the router. This is disabled by default.
Send Ack. SMS to
Select destination to send an acknowledgement message to after the execution of a “Set” command.
If “Fixed Ack. SMS Number” is selected, the acknowledgement message will be sent to the predefined number in the “Fixed Ack.
SMS Number” field.
If the SMS Sender Number is selected, the acknowledgement message will be sent to sender directly. The default setting is to use
“SMS Sender Number”.
Fixed Ack. SMS Number
Enter the destination number to which acknowledgement messages will be sent after the execution of a “Set” command.
Send Error SMS for Get/Set/Exec Command
Enable or disable the sending of an error message resulting from the execution of a Get/Set/Exec command.
If disabled, the router does not send any error notifications after the execution of a Get/Set/Exec command.
This function is disabled by default.
Send Error SMS to
Select the destination of the error messages from the execution of a Get/Set/Exec command.
If “Fixed Number” is selected, any error messages will be sent to the predefined number in the “Fixed Error SMS Number” field.
If “SMS Sender Number” is selected, any error messages will be sent to the sender directly.
The default setting is to use “SMS Sender Number”.
Fixed Error SMS Number
The destination number to which error messages from the execution of a Get/Set/Exec command should be sent.