User guide

56
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
UM-00003
www.netcommwireless.com
SNMP
The SNMP page is used to configure the SNMP features of the router.
Figure 59 - SNMP Settings
SNMP (Simple Network Management Protocol) is used to remotely monitor the router for conditions that may warrant administrative
attention. It can be used to retrieve information from the router such as the signal strength, the system time, the interface status,
etc.
To configure SNMP:
1. Select the “Enable” option for the Enable SNMP field.
2. Enter the Community Names or leave them as default.
Community names are used as a type of security to prevent access to reading and/or writing to the routers configuration. It
is recommended to change the Community names to something other than the default when using this feature.
3. Click the “Save” button to save the new settings.
ITEM
DEFINITION
Trap Destination (IP Address)
The IP Address SNMP data is to be sent to.
Heartbeat Interval (seconds)
The number of seconds between SNMP heartbeats.
Trap Persistence Time (seconds)
The length of time an SNMP trap persists.
Trap Retransmission Time (seconds)
The length of time between SNMP trap retransmissions.
Table 28 - SNMP Configuration Options
You can also trigger an SNMP Heartbeat manually by clicking the “Send Heartbeat Now” button.