User guide

UM-00003
www.netcommwireless.com
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
31
RIP
RIP (Routing Information Protocol) is used for advertising routes to other routers. Thus all the routes in the router’s routing table will
be advertised to other nearby routers. For example, the route for the router’s Ethernet subnet could be advertised to a Router on
the PPP interface side so that a Router on this network will know how to route to a device on the router’s Ethernet subnet. You will
have to add the routes appropriately in the Static Routes section – see Adding Static Routes.
Note: Some routers will ignore RIP.
Figure 31 - RIP Settings
1. Click the Enable option on the RIP Page.
2. Select the RIP version you wish to use.
3. Click the “Save RIP” button to save the settings.