Quick Start Guide

| NRB-0206-02-01

b) Compass Calibration mode - The Smart Antenna Tool contains an

electronic compass which periodically requires calibration in order to

provide the most accurate orientation possible.

Calibrate the device at every start and recalibrate when all three LED

indicators ash both red and green twice a second.

To calibrate the device, rst isolate it from any magnetic eld or metal

structures (for example vehicles, the antenna pole, power lines, etc.) and

then rotate the unit fully through all three axes, see drawings below.

When recalibration is successful, the LEDs will stop ashing.

All LEDs ashing Turn Spin Flip

c) Cell scanning mode - When the Smart Antenna Tool is connected to and

powering an Outdoor Unit (i.e. Power over Ethernet is not provided to the

Outdoor Unit). This mode is used when installing the Outdoor Unit.

Strong signal Medium signal Low signal No cell detected