Quick Start Guide

| NRB-0206-02-01
6
Charging the Smart
Antenna Tool
The included USB cable can be used to charge the Smart Antenna Tool. Connect
the USB cable from the Micro USB port on the Smart Antenna Tool to the included
AC wall charger or another 5V/2A power source for optimum charging speed.
The LED indicators on the side of the Smart Antenna Tool light up and may ash
depending on the remaining battery level. See the LED indicator section for details
on reading the battery level.
NOTE: The battery cannot be charged while it is connected to an Outdoor Unit. Do
not power off the Smart Antenna Tool while it is charging.
WARNING: Wait at least 10 seconds after powering off the Smart Antenna Tool
before connecting the USB charge cable. Failure to do so will require you to remove
the charge cable and reboot the tool by holding the power button down for 8
seconds.