Network Card User Manual

NP1100 10/100Mbps PCI Bus Fast Ethernet Card 3
YML567 Rev2
Installation
The 10/100Mbps PCI bus Fast Ethernet Card requires Hardware installation first, then
BIOS and Driver installation.
Step 1: Hardware Installation
1. Turn off your computer and disconnect the power cable.
2. Remove the cover from your computer.
Please check your computer’s documentation (particularly your warranty details) for
instructions and warnings regarding the removal of covers or installation of add-in
boards.
3. Select an empty PCI slot and remove
the appropriate expansion slot cover
from the computer.
4. Insert the card into the PCI slot and
secure with a screw in the backplane.
5. If supplied connect the WOL
(wake on LAN) cable to the WOL
connector on the card and on your
motherboard.
6. Replace the computer’s cover.
7. Insert one end of the network cable
into the socket on the PCI Network
Card.