User guide

NETCOMM LIBERTY™ SERIES – 3G39W-I - HSPA+ WiFi Router
10
NetComm 3G39W
-
I
-
HSPA+ WiFi Router User Guide
www.netcomm.com.au
YML39W
-
I
Hardware installation
1. Attach the supplied antenna to the port marked 3G Antenna. [This should be attached in a clockwise direction.]
2. Insert your SIM card (until you hear a click) into the SIM slot.
3. Connect the power adapter to the Power socket on the back of the 3G39W-I.
4. Plug the power adapter into the wall socket and switch on the power.
5. Wait approximately 60 seconds for the 3G39W-I to power up.
Connecting via a cable
1. Connect the yellow Ethernet cable provided to the port marked LAN at the back of the 3G39W-I.
2. Connect the other end of the yellow Ethernet cable to your computer.
3. Wait approximately 30 seconds for the connection to establish.
4. Open your Web browser, http://my.router or http://192.168.20.1 into the address bar and press enter.
5. Follow the steps to set up your 3G39W-I.
Connecting wirelessly
1. Ensure WiFi is enabled on your device (computer/laptop/Smartphone).
2. Scan for wireless networks in your area and connect to the network name: NetComm Wireless
3. When prompted for your wireless security settings, enter the Wireless security key: a1b2c3d4e5
4. Wait approximately 30 seconds for the connection to establish.
5. Open your Web browser, type http://my.router or http://192.168.20.1 into the address bar and press enter.
6. Follow the steps to set up your 3G39W-I.