Installation Guide POE-02 – Antenna Power Supply
Welcome Thank you for choosing a NetComm Wireless Antenna Power Supply. This guide provides simple instructions to help you quickly and easily set up your device. Package contents This package includes: 1 x Antenna Power Supply 1 x Power cord with North American plug (ungrounded) Device overview 1 2 3 2 4 POE-02 Installation Guide v1.
ITEM DESCRIPTION 1 Blue RJ45 port Provides Data + Power to the antenna. 2 Red RJ45 port Provides Power to the Residential Gateway. 3 Power switch Turns the antenna power supply on or off. 4 IEC-C8 (Figure 8) power inlet Accepts the included power cable to provide power to the Antenna Power Supply. POE-02 LED indicators POWER ANTENNA The table below describes the status of the POWER and ANTENNA LEDs on the PoE injector.
Installing the Antenna Power Supply Power over Ethernet (PoE) is a method of connecting network devices through Ethernet cable where power and data are passed along a single cable. It is therefore a convenient method of powering the Outdoor antenna. To supply power to the Outdoor antenna: 4 1. Connect a straight-through Ethernet cable (not included in the package) to the Ethernet port of the Outdoor antenna then connect the other end of the cable to the Blue RJ45 Ethernet port on the POE-02. 2.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
