User's Manual
31
Product
handling
You alone are responsible for how you use your device and any consequences of its use.
You must always switch off your device wherever the use of a mobile phone is prohibited. Do
not use the device without the clip-on covers attached, and do not remove or change the
covers while using the device. Use of your device is subject to safety measures designed to
protect users and their environment.
• Always treat your device and its accessories with care and keep it in a clean and dust-free
place.
• Do not expose your device or its accessories to open ames or lit tobacco products.
• Do not expose your device or its accessories to liquid, moisture or high humidity.
• Do not drop, throw or try to bend your device or its accessories.
• Do not use harsh chemicals, cleaning solvents, or aerosols to clean the device or its
accessories.
• Do not paint your device or its accessories.
• Do not attempt to disassemble your device or its accessories, only authorised personnel
must do so.
• Do not use or install this product in extremely hot or cold areas. The supported operating
temperature ranges are:
Class A: -30°C to +70°C
Class B: -40°C to +85°C (with possible performance deviation)
• Do not use your device in an enclosed environment or where heat dissipation is poor.
Prolonged use in such space may cause excessive heat and raise ambient temperature,
which will lead to automatic shutdown of your device or the disconnection of the mobile
network connection for your safety. To use your device normally again after such shutdown,
cool it in a well-ventilated place before turning it on.
• Please check local regulations for disposal of electronic products.
• Do not operate the device where ventilation is restricted
• Installation and conguration should be performed by trained personnel only.
• Do not use or install this product near water to avoid re or shock hazard. Avoid exposing
the equipment to rain or damp areas.
• Arrange power and Ethernet cables in a manner such that they are not likely to be stepped
on or have items placed on them.
• Ensure that the voltage and rated current of the power source match the requirements of
QSG-00075 rev 7 - MachineLink 4G QSG.indd 31 21/06/2016 10:20 AM