User's Manual
17
Follow these steps to connect your client device to the Internet over
the wireless network:
1. Turn on the wireless radio on your client device.
2. Open the wireless network manager on your client device and
connect to the Wireless Network Name (SSID) printed on the
Wireless activation card.
3. When prompted for your wireless security settings, enter the WiFi
Key. Wait a few seconds for the connection to be established.
4. Conrm that it is connected by viewing the WLAN AP status
section of the Status page.
Connecting the MachineLink 4G router to another
access point
To use your MachineLink 4G router as a client, you must rst change
the wireless mode on the web user interface. To enable the wireless
client:
1. From the top menu bar, select the Networking option.
2. Select Wireless settings on the left, then select the Wireless client
menu item.
3. Click the Client mode toggle key so that it is in the ON position
then click the Save button.
4. On the Wireless client conguration page, click the Scan button
to scan for remote access points to connect to, then click the
Connect link corresponding to the desired network. The wireless
network’s details are copied to the Wireless client conguration
elds.
QSG-00075 rev 7 - MachineLink 4G QSG.indd 17 21/06/2016 10:20 AM