User's Manual

Step 4

Connect power to your router using one of the following options.

1. DC power via the four-way connector

Remove the attached green terminal block from your router and

connect to the router’s power socket using a DC power supply,

sold separately.

2. DC power via eld terminated power source

If an 8-40V DC power supply is available, you can insert the wires

into the supplied terminal block to power your router. Use a athead

screwdriver to tighten the terminal block screws and secure the power

wires, making sure that you have correctly wired the terminal block as

illustrated below. You should avoid using DC cables greater than

2 metres in length.

QSG-00075 rev 7 - MachineLink 4G QSG.indd 8 21/06/2016 10:20 AM