User's Manual

A password (if required), only needs to be specified once per SMS, but can be prefixed to each command if desired.
“PASSWORD get Variable1”; “get VARIABLE2”
“PASSWORD set VARIABLE1=VALUE1”; “set VARIABLE2=VALUE2”
If the command sent includes the “reboot” command and has already passed the white list password check, the device keeps
this password and executes the remaining command line after the reboot with this same password.
For Example:
“PASSWORD execute reboot; getVariable1”; “get VARABLE2”
“PASSWORD execute reboot; PASSWORD get Variable1”; “get VARABLE2”
Note: Commands, variables and values are case sensitive.
List of valid commands
A list of valid commands which can be used in conjunction with the execute command are listed below:
“pdpcycle”, “pdpdown” and “pdpup” commands can have a profile number suffix ‘x’ added. Without the suffix specified, the
command operates against the default profile configured on the profile list page of the Web-UI.
# COMMAND NAME DESCRIPTION
1 reboot Immediately performs a soft reboot.
2 pdpcycle or pdpcyclex
Disconnects (if connected) and reconnects the 3G connection. If a profile number is selected in the
command, try to disconnect/reconnect the specified profile in case the profile is active. If no profile
number is selected, try to disconnect/reconnect the current active profile. Reports an error if no
profile number is selected and there is no currently activated profile.
3 pdpdown or pdpdownx
Disconnects the PDP. If a profile number is selected in the command, the router tries to disconnect
the specified profile in case the profile is active. If no profile number is selected, try to disconnect the
current active profile. Reports an error if no profile number is selected and there is no currently
activated profile.
4 pdpup or pdpupx
Reconnects the PDP. If a profile number is selected in the command, the router tries to connect with
the specified profile. If no profile number is selected, the router tries to connect to the last active
profile. The gateway will check the currently activated profile and disconnect this profile before
executing the command. The router reports an error if no profile number is selected and there is no
stored last active profile number.
5 factorydefaults Performs a factory reset on the router.
6 download
Performs a download and install of a Firmware Upgrade (.cdi), Config File (.tar.gz) or a help
document (.pdf) file.
If the file is a firmware image as in the case of a .cdi file, the router will apply the recovery image first
and then the main firmware image. The download location is specified immediately after the
command and may be from an HTTP or FTP source URL.
If the file is a .tar.gz file, the router will apply the file as a configuration file update for the device and
reboot afterwards.
If the file is a .pdf, the router will assume this is a user guide document and save it to the router and
make the file available for viewing via the help menu on the Web-UI.
Note: If your download URL includes any space characters, please encode these prior to
transmission according to RFC1738, for example:
ftp://username:password@serveraddress/directory%20with%20spaces/filename.cdi
Note: Authenticated FTP addresses may be used following the format as defined in RFC1738, for
example:
ftp://username:password@serveraddress/directory/filename.cdi
Table 18 - List of Valid SMS diagnostic commands
www.netcommwireless.com
NetComm Wireless CDMA M2M Router
77