User's Manual

Send Set command acknowledgment replies
The CDMA M2M router will automatically reply to certain types of commands received, such as get commands, or execute
commands. However replies from the CDMA M2M router are optional with set commands and the Wakeup command. This
option Enables or disables sending an acknowledgment message after execution of a set command or SMS Wakeup command.
If disabled, the router does not send any acknowledgement after execution of a set command or SMS Wakeup command. All
acknowledgment replies are stored in the Outbox after they have been sent.
This can be useful to determine if a command was received and executed by the router. This option is disabled by default.
Send acknowledgment replies to
This option allows you to specify where to send acknowledgment messages after the execution of a set, or exec command.
If a fixed number is selected, the acknowledgement message will be sent to the number defined in the Fixed number to send
replies to field. If the sender’s number is selected, the acknowledgement message will be sent to the number that the SMS
diagnostic or command message originated from. The default setting is to use the sender’s number.
Fixed number to send replies to
This field defines the destination number to which acknowledgement messages are sent after the execution of a set, or exec
command.
Send command error replies
Enables or disables the sending of an error message resulting from the execution of a get, set, or exec command. All error
replies are stored in the Outbox after they have been sent.
If disabled, the router does not send any error notifications after the execution of a get, set, or exec command. This function is
enabled by default.
Send error replies to
This option allows you to specify where to send error messages from the execution of a get, set, or exec command.
If a fixed number is selected, any error messages will be sent to the number defined in the fixed number to send error
replies to field. If the sender’s number is selected, any error messages will be sent to the number that the SMS diagnostic or
command message originated from. The default setting is to use the sender’s number.
Fixed number to send error replies to
This field defines the destination number to which error messages are sent after the execution of a get, set, or exec command.
Send a maximum of ___ replies per ___
You can set the maximum number of acknowledgement and error messages sent when an SMS diagnostic or command is
executed. The maximum limit can be set per hour, day, week or month. The router will send a maximum of 100 replies by
default.
The number of messages sent is shown below the options. The total transmitted message count resets after a reboot or at the
beginning of the time frame specified.
www.netcommwireless.com
NetComm Wireless CDMA M2M Router
73