User's Manual

RIP
RIP (Routing Information Protocol) is used for advertising routes to other routers. Thus all the routes in the router’s routing table
will be advertised to other nearby routers. For example, the route for the router’s Ethernet subnet could be advertised to a router
on the PPP interface side so that a router on this network will know how to route to a device on the router’s Ethernet subnet.
Static routes must be added manually according to your requirements. See Adding Static Routes
.
Note: Some routers will ignore RIP.
Figure 40 - RIP configuration
To enable Routing Information Protocol (RIP)
1. Click the RIP toggle key to switch it to the ON position.
2. Using the Version drop down list, select the version of RIP that you would like to use.
3. Click the Save button to confirm your settings.
www.netcommwireless.com
NetComm Wireless CDMA M2M Router
37