User's Manual

Band Settings

The band settings page lets you configure the roaming preference and mode of the radio.

LAN

LAN configuration

The LAN configuration page is used to configure the LAN settings of the router and to enable or disable DNS Masquerading.

Figure 31 – LAN configuration settings

The default IP of the Ethernet port is 192.168.1.1 with subnet mask 255.255.255.0. To change the IP address or Subnet mask,

enter the new IP Address and/or Subnet mask and click the Save button.

Note: If you change the IP address, remember to reboot the router and enter the new IP address into your browser

address bar.

Local DNS Server (DNS masq)

DNS masquerading allows the router to proxy DNS requests from LAN clients to dynamically assigned DNS servers. When

enabled, clients on the router’s LAN can then use the router as a DNS server without needing to know the dynamically assigned

cellular network DNS servers.

With DNS masquerading ON, the DHCP server embedded in the CDMA M2M router hands out its own IP address (e.g.

192.168.1.1) as the DNS server address to LAN clients. The downstream clients then send DNS requests to the CDMA M2M

router which proxies them to the upstream DNS servers.

NetComm Wireless CDMA M2M Router