User's Manual

www.netcommwireless.com
NetComm Wireless 3G M2M Router / Plus
11
Interfaces
NTC-6200-01, NTC-6200-02, NTC-6200-11 and NTC-6200-12 models
Figure 4 - Interfaces - NTC-6200-01, NTC-6200-02, NTC-6200-11 and NTC-6200-12 models
NO.
ITEM
DESCRIPTION
1
Main antenna socket
SMA female connector for main antenna.
2
Aux antenna socket
SMA female connector for auxiliary antenna (receive diversity).
3
GPS antenna socket
SMA female connector for an active GPS antenna.
4
Six-way terminal block connector
Connect power source, ignition and I/O wires here. Power, ignition and I/O wires may be terminated on
the supplied terminal block and connected to a power source. Refer to the diagram and table under the
Installation section for correct wiring of the terminal block. Operates in the 8-40V DC range.
5
Reset button
Press and hold for less than 5 seconds to reboot to normal mode.
Press and hold for 5 to 15 seconds to reboot to recovery mode.
Press and hold for 15 to 20 seconds to reset the router to factory default settings.
6
SIM card slot
Insert SIM card here.
7
SIM tray eject button
Press to eject the SIM tray
8
Torx screw hole
If desired, place the SIM tray cover over the SIM card slot and fix it to the router’s body using the included
Torx screw.
9
RJ45 PoE Ethernet port
Connect one or several devices via a network switch here. This port can also optionally receive Power
over Ethernet (802.3af PoE) in which case the DC power supply can serve as a backup power source if
required. (PoE available on NTC-6200-01 and NTC-6200-11 only).
10
Mini USB 2.0 OTG port
Provides connectivity for optional external storage or a USB Ethernet dongle. Supplies up to 0.5A to
connected device.
11
Serial port
Female DB9 port supporting 9-wire RS-232, RS-485 or RS-422 (software selectable).
Table 6 – Interfaces - NTC-6200-01, NTC-6200-02, NTC-6200-11 and NTC-6200-12 models
8
1
2
3
4
5
6
7
9
10
1
11