User's Manual
YML40V
www.netcomm-commercial.com.au
NTC-40WV –HSPA+ M2M WiFi Router with Voice
69
HSPA+ M2M WiFi Router with Voice NETCOMM WIRELESS M2M SERIES – NTC-40WV
Remote firmware upgrade
The remote firmware update process has one step:
1.
Upload and install the main system image to the router.
Please note: Do not interrupt the power during a remote firmware upgrade, as this may render the router unable to start up and will require a local system recovery upload to be
performed.
Upload and install the system recovery image onto the router. You can do this by clicking on the browse button and then to navigate to where the recovery image upgrade file is located on your
computer.
Once you have selected the recovery image file to use, click Upload to upload the file. You will then see a progress bar as shown in the screenshot below. The upload has finished when the
status bar reaches 100%.
Figure 60 - Remote Firmware Upgrade - Upload Firmware
When the upload has completed, the screen should refresh and list the file you have just uploaded. Click on the “Install” link to the right of this.
Once you see “Done” shown as per the screenshot below, the router will have automatically reboot, and installed the new main system image. It should also reconnect to your selected Internet
service.
Figure 61 - Remote Firmware Upgrade - Firmware Update
Please note: This process can take up to 10 minutes.