User's Manual

56
NTC-40WV HSPA+ M2M WiFi Router with Voice
YML40V
www.netcommwireless .com
HSPA+ M2M WiFi Router with Voice NETCOMM WIRELESS M2M SERIES NTC-40WV
Diagnostics
The Diagnostics page is used to configure the SMS Diagnostics and Command execution configuration. This enables you to change the configuration or check on the status of the router via
SMS commands.
Figure 49 - SMS Diagnostics Settings
The following section details the configuration items available.
Enable Authentication
Enable or disable checking the sender’s phone number against the allowed sender “White List for incoming Diagnostics/Command Execution SMS messages.
If authentication is enabled, the router will check if the sender’s number exists in the “White List. If it exists, the router then checks the password in the incoming message against the password
in the “White List” for the corresponding sending number. If they match, the Diagnostics/Command is executed.
If the number does not exist in White List or the password does not match, the router does not execute the incoming Diagnostics/Command Execution SMS message.
This is enabled by default.
It is highly recommended to enable security when utilising the Diagnostics/Command Execution feature.
Send Ack. SMS for Set Command
Enable or disable sending an acknowledge message after execution of a “Set command. If disabled the router does not send any acknowledgement after execution of a “Set command.
This can be useful to determine if a command was received and executed by the router. This is disabled by default.