User's Manual

10
NTC-40WV –HSPA+ M2M WiFi Router with Voice
YML40V
www.netcommwireless .com
HSPA+ M2M WiFi Router with Voice NETCOMM WIRELESS M2M SERIES – NTC-40WV
Integrated Interfaces
The following integrated interfaces are available on the NTC-40WV:
1 2 3 4 5
Figure 3 - Bottom Mounted Integrated Interfaces
ITEM
INTERFACE
FUNCTION
1
Diversity Receive 3G Antenna
Connect one of the 3G antennas here
2
SIM Card Reader Tray Eject button
Push in with a paper clip to eject the SIM card reader tray.
3
SIM Card Reader Tray
Insert the SIM Card reader tray with a SIM inserted here.
4
Mini USB 2.0 Console Port
Connect a Mini USB cable to access the NTC-40WV console here. The current firmware version does not implement this port but
it may be included in a future firmware release.
5
Main 3G Antenna
Connect one of the 3G antennas here.
Table 4 - Bottom Mounted Integrated Interfaces
1 2 3 4 5 6
Figure 4 - Top Mounted Integrated Interfaces
ITEM
INTERFACE
FUNCTION
1
WiFi Antenna Port
Connect one of the WiFi antennas here
2
Captive Power Terminal
Connect the supplied power cable here.
3
RJ-11 Telephone Cable Port
Connect a PSTN telephone here in order to make calls via the 3G connection.
4
RJ-45 Ethernet Port
Connect an Ethernet cable here.
5
Reset button
To reboot the router push and hold the reset button for one second to reboot the NTC-40WV.
To boot the router into system recovery mode hold the reset button for approximately 10 seconds until the LEDs on the front of
the router start to flash in an ON / OFF sequence and then release it.