User's Manual

NTC-3000 Series
www.netcommwireless.com
NTC 3000 Series – M2M Serial Modem
47
set server= ip address/hostname, port
Sets the server IP address or hostname and port that the NTC-3000 will use when operating in TCP server mode.
set dyn_enable=0,1
When this value is set to 1, the NTC-3000 automatically updates the IP address from the dynamic DNS host. When this value is set to 0, the dynamic DNS feature is disabled.
set dyn_host=xxx
Sets the Dynamic DNS hostname.
set dyn_user=xxx
Sets the Dynamic DNS username.
set dyn_pass=xxx
Sets the Dynamic DNS password.
set serial_on_start=0,1
When this value is set to 1, the NTC-3000 enables the serial port when the unit boots up. When this value is set to 0, the NTC-3000 will not start the serial port on boot.
set force_reset=xxxxx
Sets the FORCE_RESET period in minutes. Valid intervals are 2 – 65535 minutes. Setting this value to 0 disables the forced reset function.