User's Manual

NTC-3000 Series
www.netcommwireless.com
NTC 3000 Series – M2M Serial Modem
45
get settings
The NTC-3000 replies with the following information:
APN: testAPN
PDP: [e-mail], test
SERVER: 10.1.193.11,1516
PAD: 1
DYN_ENABLE: 1
DYN_HOST: testuser.dyndns.org
DYN_USER: testuser
DYN_PASS: testpass
get version
The NTC-3000 replies with the version of the NetComm Wireless custom application.
get force_reset
The NTC-3000 replies with the current FORCE_RESET period.
get serial_on_start
The NTC-3000 replies with the current SERIAL_ON_START flag.
execute reboot
Instructs the NTC-3000 to perform a reboot immediately.
execute save
Instructs the NTC-3000 to save the current settings to on-board flash memory.
execute pdpcycle
Instructs the NTC-3000 to stop the current PDP session and reconnect it.
execute pdpdown
Instructs the NTC-3000 to stop the active PDP session.
execute pdpup
Instructs the NTC-3000 to connect the PDP.
set apn=xxxxx
Sets the APN used to connect to the PDP session. The new APN will take effect after performing the “execute pdpcycle” command. This new APN won't be saved to on-board flash
memory unless the “execute save” command is issued.
set pdpauth=”user name”,”password”
Sets the username and password used for authentication to the PDP session.
set smspassword=XXXXXX
Sets the SMS password required as a prefix for all SMS commands. The password may be a maximum of 6 characters in length.
set pad=0,1,2,3
Sets the NTC-3000 mode of operation where “0” is “PAD disabled mode", “1” is "TCP client mode", “2” is "TCP server mode" and “3” is "UDP client mode".