User's Manual

NTC 3000 Series – M2M Serial Modem
44
www.netcommwireless.com
Configuration through SMS
The NTC-3000 can be configured through the serial port with AT commands or remotely through SMS messages. When configuring the NTC-3000 using SMS messages, all the
messages must be prefixed with a password.
The following is a list of SMS commands that may be used:
1. get status
2. get settings
3. get version
4. get force_reset
5. get serial_on_start
6. execute reboot
7. execute save
8. execute pdpcycle
9. execute pdpdown
10. execute pdpup
11. set apn
12. set pdpauth
13. set smspassword
14. set pad
15. set server
16. set dyn_enable
17. set dyn_host
18. set dyn_user
19. set dyn_pass
20. set serial_on_start
21. set force_reset
get status
The NTC-3000 sends an SMS reply with the following information:
IMEI:xxxxx
UpTime:xx:xx:xx
Connection UpTime:xx:xx:xx
IP:xxx.xxx.xxx.xxx