User's Manual

NTC 3000 Series – M2M Serial Modem
36
www.netcommwireless.com
AT+Save
Description: Saves any changes made to the settings using commands in this list. Changes to settings using the commands in this list do not take effect immediately
and must be saved to the board’s flash memory using this command, followed by a reboot. The exception to this is the AT+PAD command which initiates a
save command and reboots the device.
Usage: To save settings to the onboard flash memory
AT+SAVE=1
Example: To save settings to the onboard flash memory, enter
AT+SAVE=1
Then enter
AT+CFUN=1
to perform a reboot so that the new settings take effect.
AT+CFUN
Description: This is a standard AT command which resets the device.
Usage: To reset the device
AT+CFUN=1
AT+SMS_DIAGNOSTICS
Description: Sets the status of the SMS Diagnostics feature on the NTC-3000.
Usage 1: To set the status of SMS Diagnostics
AT+SMS_DIAGNOSTICS=x
Where ‘x’ is an option number.
Help: AT+SMS_DIAGNOSTICS=?
Options: 0 disabled
1 enabled
Example: To enable SMS Diagnostics, enter
AT+SMS_DIAGNOSTICS=1