User's Manual
Table Of Contents
- Introduction
- Target audience
- Prerequisites
- Notation
- Product overview
- Product features
- Package contents
- Physical dimensions
- LED indicators
- Ethernet port LED indicators
- Interfaces
- Mounting options
- DIN rail mounting bracket
- Wall mounted via DIN rail bracket
- DIN rail mount
- Pole mount using DIN rail bracket
- Desk mount
- Powering the router
- Installing the router
- Data Connection
- Connect on demand
- SIM Management
- Operator settings
- SIM security settings
- LAN
- Wireless settings
- Ethernet LAN/WAN
- WAN failover
- Routing
- VPN
- Dynamic DNS
- Network time (NTP)
- Data stream manager
- PADD
- SNMP
- TR-069
- GPS
- USSD
- IO configuration
- SMS messaging
- Diagnostics
- Sending an SMS Diagnostic Command
- Log
- System configuration
- Administration
- Watchdogs
- Power management
- USB-OTG
- Storage
- Reboot
- Restoring factory default settings
- Accessing recovery mode
- Status
- Log
- Application Installer
- Settings
- Reboot
- Overview
- Accessing USB/SD card storage devices
- Host and Device mode
www.netcommwireless.com
NetComm Wireless 4G WiFi M2M Router
43
UM-00009
Client configuration
As a wireless client, the NTC-140W is able to connect to another wireless access point to gain network or internet access. The
Client configuration page provides the ability to turn on or off the wireless radio, find nearby access points and configure a
connection to an access point.
The NTC-140W may run both Access Point and Client simultaneously, however, since they share the wireless channel, both client
and access point must use the same channel.
Figure 49 - Wireless settings - Client Configuration
OPTION
DEFINITION
Client radio on/off
Turns the wireless radio on or off.
Status
Displays the current channel and connection status of the wireless client.
Metric
The metric value is used by the router to prioritise routes.
SSID to connect
Enter the SSID of the network you wish to connect to or you may use the Scan button to discover nearby
networks.
AP BSSID
The BSSID or MAC address of the access point to which you are connecting.
Network authentication
The type of authentication in use on the network.
WPA pre-shared key
Enter the pre-shared key required to join the wireless network.
WPA encryption
Select the type of encryption in use on the network.
Table 17 - Wireless settings – Client Configuration