User's Guide
Table Of Contents
23 of 64
CBRS Survey UE – User Guide
UG01287 v0.6 December 1, 2020
10 Plug the Ethernet cable into the Ethernet port.
Figure 17 - Plugging in the Ethernet cable
11 Put the neck into the opening and turn the neck clockwise until it locks in place.
12 Push the rubber seal and ferrule into the neck then screw the nut on to the neck.
Figure 18 - Rubber seal and ferrule inserted into neck
13 Turn the nut clockwise to tighten it the washer seal against the housing. Continue turning the nut until
completely assembled. This will allow the washer seal to grip the cable while also applying enough pressure
to the washer seal to prevent dust and moisture entering the unit.
Figure 19 - Turning the nut clockwise