User's Manual

HSPA WiFi Router with Voice User Guide YML10WVR
6 www.netcommlimited.com
1.3 LED Indicators
The front panel LED indicators are shown in this illustration and followed by detailed explanations in the table below.
LED COLOR MODE DESCRIPTION
POWER Blue On Power on
Off Power off
Phone Blue On Phone line active
Off Phone line inactive or not connected
Flashing New Voice mail
LAN 1~2 Blue On Powered device connected to the associated port (includes
devices with wake-on- LAN capability where a slight voltage
is supplied to an Ethernet connection)
Off No activity, modem powered off, no cable or no powered
device connected to the associated port
Blink LAN activity present (traffic in either direction)
WiFi Blue On The wireless module is ready.
Off The wireless module is not installed.
Blink Data being transmitted or received over WiFi.
Internet Blue Blink Data is transmitted through Internet connection
Off No connection to the internet or router powered off
On Internet connection established
3G Blue On Internet connection established.
Blink Connecting with UMTS cellular station
Off No connection with UMTS cellular station, no activity or
router powered off.
2G Blue On Internet connection established.
Blink Connecting to an EDGE, GPRS or GSM cellular station
Off No connection with EDGE, GPRS or GSM cellular station, no
activity or router powered off.
Low Blue On Low signal strength
Off No activity, router powered off or on other signal strength
Med Blue On Medium signal strength
Off No activity, router powered off or on other signal strength
High Blue On High signal strength
Off No activity, router powered off or on other signal strength
NOTE: The six LEDs on the right side of the front panel display (Internet, 3G, 2G, Low, Med, High) will cycle on and off if PIN code protection is activated. In this case, you
should consult section 4.2.1 PIN Code Protection for further instructions.
1~2