User's Manual
YML10WVR HSPA WiFi Router with Voice User Guide
www.netcommlimited.com 35
NETCOMM LIBERTY SERIES - HSPA WiFi Router with Voice
OPTION DESCRIPTION
IP Address Enter the IP address for the LAN interface
Subnet Mask Enter the subnet mask for the LAN interface
Enable UPnP Tick the box to enable Universal Plug and Play
Enable Half-Bridge The Router can be set up as a half- transparent bridge to cope with some
special applications such as VPN pass-through. By default half- bridge is off.
Please refer to Appendix B for more information.
Enable Internet Group Management Protocol (IGMP) Snooping Enable by ticking the box
Standard Mode: In standard mode, multicast traffic will flood to all bridge ports when no client
subscribes to a multicast group.
Blocking Mode: In blocking mode, the multicast data traffic will be blocked. When there are no
client subscriptions to a multicast group, it will not flood to the bridge ports.
Dynamic Host Configuration Protocol (DHCP) Server Select Enable DHCP server and enter your starting and ending IP addresses
and the lease time. This setting configures the router to automatically assign IP,
default gateway and DNS server addresses to every DHCP client on your LAN
Enable NAT To enable/disable Network Address Translation (NAT, please refer to 7.2 for NAT
setting). By default NAT is enabled.
Option 42, 66,150,160 These options are used for special DHCP set up.
Static IP Lease List To specify the IP address assigned through DHCP according to the MAC address
of the hosts connected to HSPA WiFi Router.
Enable DHCP Server Relay To relay DHCP requests from the subnet with no DHCP server on it to a DHCP
server on other subnets. DHCP Server Relay is disabled by default. To access
enable DHCP relay, please un-tick NAT enable first, that means to disable NAT
first, and then press save button. The Enable DHCP server Relay option will then
show up on the same page as below:
Enable Half-Bridge the Router can be set up as a half- transparent bridge to cope with some special
applications such as VPN pass-through. By default half- bridge is off. Please
refer to Appendix B for more information.
Enable NAT To enable/disable Network Address Translation (NAT, please refer to 7.2 for NAT
setting). By default NAT is enabled
Option 42, 66,150,160 These options are used for special DHCP set up
Static IP Lease List To specify the IP address assigned through DHCP according to the MAC address
of the hosts connected to HSPA WiFi Router
Enable DHCP Server Relay To relay DHCP requests from the subnet with no DHCP server on it to a DHCP
server on other subnets. DHCP Server Relay is disabled by default. To access
enable DHCP relay, please un-tick NAT enable first, that means to disable NAT
first, and then press save button. The Enable DHCP server Relay option will then
show up on the same page as below
IP Address: Enter the secondary IP address for the LAN interface.
Subnet Mask: Enter the secondary subnet mask for the LAN interface.