User's Manual

YML10WVR HSPA WiFi Router with Voice User Guide
www.netcommlimited.com 11
NETCOMM LIBERTY SERIES - HSPA WiFi Router with Voice
Web User Interface
This section describes how to access the device via the web user interface using a web browser such as Microsoft Internet Explorer
(version 6.0 or later).
3.1 Default Settings
The following are the default settings for the device.
 Local (LAN) access (username: admin, password: admin)
 Remote (WAN) access (username: support, password: support)
 User access (username: user, password: user)
 LAN IP address: 192.168.1.1
 Remote WAN access: disabled


 
Technical Note:




3.2 TCP/IP Settings
It is likely that your computer will automatically obtain an IP Address and join the network. This is because the Dynamic Host



Windows XP/Vista/7
DHCP Mode

PC for DHCP mode, check the Internet Protocol properties of your Local Area Connection. You can set your PC to DHCP mode by
selecting Obtain an IP address automatically in the dialog box shown below.