Operation Manual

14
NetBotz USB Coordinator & Router Installation Guide
Monitoring the USB Coordinator & Router
Overview
Once your wireless sensor network is installed and receiving power, you can
begin monitoring your system using the software interface for the appliance.
See your appliance installation and quick configuration manual for
system installation details and for instructions on accessing the
software interface of the appliance.
Sensor listing
When a USB Coordinator & Router is selected in the Navigation Pane in
Advanced View, the following sensor is listed in the Sensor Pane (Router mode
only):
Receiving and sending data
The USB Coordinator & Router passes data back and forth between the host
appliance and any Routers or End Devices on the wireless sensor network as
necessary.
If there is a significant change, each End Device sends its own data every 30
seconds. If there is no change, the End Device waits up to three (3) minutes
before sending sensor data to indicate it is still alive.
End Devices do not extend the wireless network or pass data to other End
Devices on the network.
Sensor Description
RSSI The Received Signal Strength Indicator. This indicates the
strength of the signal the Router receives from its parent
(either another Router or the Coordinator).
A reading above 30% RSSI is ideal.