Operation Manual

NetBotz USB Coordinator & Router Installation Guide
13
Using the Reset Button
Overview
The reset button on the front of the USB Coordinator & Router is used to reboot
it, or reset it to the factory default settings.
Reboot. When the reset button is given a short press (less than 3 seconds), the
Status LED flashes green, and the sensor reboots with the current settings in
place.
Reset to factory defaults. Press and hold the reset button for at least 5
seconds. The Status LED flashes green, and after about three seconds, changes
to solid red until the button is released. The sensor will reset, erase its current
settings, and restore the factory default settings.
Note: During the initial 45-second startup time, the Reset button is
disabled. Once startup is complete, the button functions normally.